Image Image Image

Valid HTML 4.0!
Valid CSS!


Image
 

Image
Philips PM2813 #2

Image

Switch mode power supply
3 x 60 Volt / 5 Ampere / 60 Watt

Deze voeding is nog defect. Grootste probleem is een defect LCD.

Specifications:

OUTPUT   module 60 V - 5 A - 60 W
Output Voltage range 0 to 60 V
Output Current range 0 to 5 A
Output Power 60 W
Overvoltage protection range 2 to 62 V
Accuracy (at calibration temperature)
Output Voltage ± (0.04 % of setting + 20 mV)
Output Current ± (0.1 % of setting + 25 mA)
Over Voltage Protection ± (0.5 % of setting + 250 mV)
Temperature coefficient
Output Voltage (0.016 % of setting + 2 mV)/K
Output Current (0.05 % of setting + 2 mA)/K
Long term drift (in an 8 hour period)
Output Voltage 0.04 % of setting + 5 mV
Output Current 0.05 % of setting + 10 mA
Programming Resolution (12bit)
Output Voltage 15 mV/LSB
Output Current 1.25 mA/LSB
Over Voltage Protection 15 mV/LSB
Source Effect (For any line voltage change within rating)
Voltage ± (0.01 % of setting + 2 mV)
Current ± (0.02 % of setting + 2 mA)
Load Effect (load change 10 % to 90 %
Constant Voltage or 90 % to 10 % full load)
Constant Current ± (0.01 % of setting + 5 mV)
Load cross regulation ± (0.02 % of setting + 5 mA)
Output Noise (PARD) Negligible for both voltage and current
Constant Voltage pp/rms 30 mV/6 mV
(40 Hz to 30 MHz)
Constant Current rms 10 mA
Switching Frequency approx. 20 kHz
Accuracy (at calibration temperature)
Voltage ± (0.05 % + 50 mV)
Current ± (0.1 % + 15 mA)
Measuring Resolution (12 bit)
Voltage resolution to   interface 15 mV
Current resolution to   interface 1.25 mA
Voltage resolution to display 10 mV
Current resolution to display 10 mA
Max. Current at 5 A
Reverse voltage
REMOTE SENSE > 0.25   Volt drop per lead (at open sense connections, the output voltage will not be   more than 3 V above the programmed value)
DYNAMIC OPERATION ÆI=0.5 A between 0.5 and 5 A
Settling band
dI/dt ± 50 mV
Overshoot < 0.5 A/µs
Recovery time < 150 mV
Programming response < 2 ms
Up (0 V to max. output) 200 ms @ 1 A
Up (0 V to max. output) 100 ms @ (no load)
Down(max. output to 1 V) 200 ms @ 1 A
Down (max. output to 1 V) 500 ms @ (no load)
Reprogramming delay
Range 100 ms to 60 s
Resolution 1 ms
Default 100 ms
Step Interval time up to 60 s

 

Reacties:
Er zijn nog geen reacties op deze pagina.


Uw e-mail adres zal niet worden getoond.

Image

Image beast-nylons beast-nylons
Image